How to hook up inputs and outputs in Mach3

good ,but need it in 720 or 1080 resolution

Hi, China I have bought one CNCEST 6090 ,in any setting will not move at all could you help me what I must to do?

Thanks this is very helpful and well explained. Cheers

what could cause the digitize light to be on without anything being installed . I was trying to install a touchplate on pin 11, but with the digitize light on it will not work

tried 10 and 11 set the same way, and mine does not show anything. Wires are proper and everything lights up on the hardware, so I'm stuck.

Is there any way to increase the number of inputs and outputs using the USB controller?

Great

Hi Sir,

I can see you are an expert..! I hope you can help me..!

Can you demystify some of my worries..?


There is lot of confusion regarding the reliability and consistency of mach3 as it is PC based and USB or Parallel port.! Lot of people say that it may behave funny in the middle of a project and it may ruin the entire job..!

which can be caused by slight voltage spikes from nearby high power accessories like VFD or Motors. And relying fully on PC for CNC operation is not recommended. I am so worried about all these..!

I am not sure how much immunity against such HF-RF Noise shielded cables can offer..!


But dedicated CNC controllers like Masso and RichAuto are insanely priced.! and I don't have access to USA or Euro Based other CNC Controllers here..!

People have also mentioned that If signal voltage is high (24v or higher) It can withstand such interferences..!
But mach3 operates at 5V only..! So there is high chance of signal contamination..!
Is that a huge concern..?

Mach3 Boards are affordable.
But If I cant use them for longer projects , then there is no point in spending money for all the parts which are still expensive..!

I am so worried..!


Secondly,
I have seen in videos that
The baud rate that mach3 communicates at , is not adequate to drive powerful servos..! !
So Only steppers at low power application is possible with Mach3.

That is so discouraging..!


Can you help me?

Master which card do you use🥀
I use the green card and motion card
But it is not works in the both

Another "expert video" without expertice