Orange Spektrum DSM2 Receiver Binding Process

Did you already a range test? I have since this weekend also a DX8 and when I was doing a range test I lost the signal after 10 seconds working? Greetings

Hi there, These receivers have so far been range tested to approx 500m. This is as far as you can really see a plane, i am confident it would go further. Regards

Perfectly clear and all details covered. Thanks you, Sir. (Haven't done it yet, but do not doubt it will work, because your video leaves no room for questions.) Thanks again

@100randydmaster Minimum voltage for binding is 5V. You can decrease the voltage down to around 4V for operation after binding. Hope this helps! ProFlight-UK

@proflightuk Thanks for the demo video. Would you trust this Rx for a .40 size or perhaps larger plane?

@gmccord1970 Hi there These receivers by themselves are best suited to parkflyer models. For added security i would recommend the satellite receiver. Also we have the 6ch receiver + satellite receiver together as a package available. For ultimate security we also have the 9ch version available, these are full range and they accept 2 satellite receivers. Hope this helps. ProFlight-UK

Good job. I want to hire you to help me build robots. Contact me at [email protected] Everyone is welcome.

Can i simply make the bind plug by myself? Because i don't have one. Will it work if i do the same on a spektrum dx 7?

@Mattieboy090809 Yes you can make a plug yourself, it is just a simple wire. Yes Spektrum DX7 is 100% compatible with this product! ProFlight-UK

@proflightuk Thank a lot. Great video.

Thank you for posting.

Thanks

Is there any info (anywhere) how to connect & setup this receiver to the NAZA M? I finally bit the bullet and ordered the NAZA M yesterday but I cannot find any info anywhere on how to set it up with an Orange receiver!

can this receiver binding with KDS7ch transmitter?

I need help please !! I have spektrum dx5e and the orange RX FASST (2.4 ghz) 8ch reciever...I have a bind plug, I tried everything, no binding, |I even tried to switch the transmitter to dsm2 (DSMX being the factory setup\) What am I doing wrong, I am going insane here ! Thanks.

thanks you love!

Can that use for magnet acutor

can it bind with dx4e

Cherrs brother

Olá amigo!!! Meu receptor orange funciona mt bem com o rádio DX7. Só que se o rádio for desligado na chave, o receptor liga sozinho o motor acelerado ao máximo. O DX7 fica inoperante depois disso. o que pode ser?