2 Homemade Cable Clamp Ideas

Thanks Brother.. your Idea is valuble for preassure washer pipe fitting.. 👌

Good tools

Thanks for sharing

Very good😊

I would have used a molly Hogan loop on the first one. Could have been done 30 minutes ago

My partner grabbed a perimeter 3/8" wire cable walking a steel beam about 18' up.
The investigation blamed a faulty wire rope clip/cable clamp. When he fell to ground a pc of rebar penetrated his upper body pinning him to it; One end was sticking through his back and he told me to tell his wife and kids...blah blah he died in front of me almost 15 minutes later. THEN the medics arrived.

Great idea my friend

Sempre muito bom 👍

with second method I have maded a clamp for a hydraulic pump, over 120bar (1800psi) and is very good.

I use the second to make a high pressure clamp.. thank you

Called a split bolt clamp. Who'd have thought? These are easily cross-threaded and can snap on the thread so use with caution.

Если из говна сделать пулю то она и полетит как говно!

Can you just drill a hole in the bolt, thread the wire through and tighten a nut to secure the wire ?

Excelente

Muito boas suas ideias gostei abraço amigo

ДРУЖИЩЕ НЕ ОБИЖАЙСЯ НО ЭТО ДЕЙСТВИТЕЛЬНО ПОЛНАЯ ХРЕНЬ

ПОЛНАЯ ХРЕНЬ

Good,,,👍👍👍
To friends of 1 professions let's be friends with each other👌👌

Muito criativo goste muito 👏👏👏👍👍👍🙏🙏

Very clever, especially the first one :-)

Good job