How to Wire a DC Speed Controller to Actuator: Full Instructions - Progressive Automations

if down speed the streght is increase? the lbs is more hight?

how many amps buy speed control ? my linear actuator 12 volt and 3 amp

That's cool. Will that work to reverse the polarity of an electric trolling motor?

Good evening Sir/Madam,

I am looking at reducing the vibration in a Wildcat helicopter.

Obviously due to the cost i am unable to use a full size military Wildcat so i am looking to prove my concept works on a radio controlled helicopter.

I need to measure the phase of the main rotor head so i can ensure the dc motor i will be using as the “shaker” will be 180 degrees out of phase therefore reducing or minimising the vibrations. This is where i am struggling, your clip is exactly what i am hoping to achieve altohugh it would need to be considerably faster to nullify or reduce the helicopter vibration

I would appreciate your expert opinion as to what components would be best for me to purchase off your website to achieve this information,

Best regards

Mark Sheldon

What is the slowest speed ?

Is there any way to wire it so it moves continuously?

Can you use this DC Speed Controller with your relays and Arduino? Basically can you control the linear actuator with the Ardunio, but adjust speed with the DC speed controller?

Hi,
Can we increase the speed of the linear actuators on and above the spec?

What its missing is the max speed for instant the actuator said 10mm/s if we use the speed control it will increase to 20mm/s ???

Would this work on a linear actuator. 6000n rated for 1320lbs??? Direct wire it's very slow. My application was for a small garden tractor loader. I need more speed. Don't want to purchase another actuator so I'm trying to find how to increase the speed .

I have ur remote control kit hooked up to 2 actuators one is a tab bit slower than the other do I hook this up to both of them or do I hook jus the slow one up ????

Do you need the rocker switch? Just need full out and back on a slider.

Can I use this to control a power table with bad power box?
I have some power tables- The motors or actuators are still good but the control boxes went bad

1aa

are all actuators the same speed or could you increase it even more? thanks

Progressive Automations_Can you tell me how much does this whole kit will cost?