KISS FC v2 REPAIR (water damage)

great work yet again livyu nice 1 bro

Another cracking job !

maybe next repair switching regulator on omnibus f4 pro

I enjoy our project greatly Sir !
Just curious, what do you do with the parts you repair ? You get to keep and use ? Or do you send them back to the guy with a bill 😬

Can the corroded esc u showed be repair?

I always look forward to your repair video's. It's amazing what you can do with hot air and good eyes!

I have kiss v2 where the inductor got knocked off. The one right beside the missing diode on your video. Would you have a part number or specs for it? I can message a photo if needed.

Amazing work Livyu!

What solder paste you use?

Very well done ! great video.

My conclusion here - never give up! Thanks for the video, man.

Your language is good actually you explain sufficiently 👍🏻👍🏻

Hi, what diode do you use? The "SL" diode is like SOD-523? I can not find "ACC" diode. Thanks in advance!

You're English is better than my Romanian! Great videos

So clear !!!! Very helpfull !!!

loving your vids. What the model of digital microscope?

What are your thoughts on driller out the holes for gummies? Looks like this FC in your video was drilled out. I know the flexible standoffs don't work good for KISS V2, but soft mounting the FC and ESC should protect from the components when the frame flexing in crashes. Probably minimal movement compared to flexible standoffs?

Unde zbori? Am ceva reparatii,multumesc

Impressive!

Hi Livyu can i get you email?.... or othres contact?... i need Help for my Kiss V2.... Thank you.!

Hi friends can you help me where I get the tool you are changing, not long ago it flew down and down, can you send a link for me to buy the component filter

salut buna dimineata am un sarut v2 si conectez pad-ul prost al placii de pbd MR STEELE si ard ceva din motor 4 toate motoarele functioneaza meos cele 4 as dori sa repare Sper raspunsul tau multumesc

Great video thank u

My flight controller and esc got wet by falling into about 3 inches of water yesterday I cleaned with alcohol and it’s “working” fine but motors get hot, swapped all 4 motors still hot. Could something have fallen off the fc from this 20 second contact with water? When I got to the quad it was disarmed but motors were spinning on and off randomly. If you have any ideas let me know 🤞

Where can I buy that inductor that filters the input voltage?

hey livyu i love your repair videos and you can really learn something! Unfortunately I also broke a kiss v2 after cleaning ... do you repair something like that privately?

Hi,
I wanted to ask, if replace a burned processor, will have to install a new firmware, a new serial number. Is this on request from flyduino?

Wich alcohol do you use to clean your fc’s and escs?