How to connect betaflight to PC simulator | Connect any transmitter to any sim

Nice

Okay when I get home from work I'm definitely going to try that

I am using Arris x220 a 5 inch drone

Even this way I can't get it to work. When I type get USB HID CDC value on, it says error invalid name

4. something

for me i get massive delay for some reason cant figure out how to fix it

I have a betafpv literadio 2 and when i plug it in to my pc it works but the controls are way off, for example the steering stick does something way different than steering, any tips?

What?And i must turn on my quad all time while im playng?That wwill fry my VTX on drone,and maybe even flight controler.That is dangerous.....How can i conect just my Jumper T8SG Plus via USB CABLE TO PC?

This is how I tend to connect these days to a sim. I have an old F4 FC running customised 3.4 and an FrSky Rx in a little box. It is all powered by the USB to FC connection.

Worth noting though that after some measurement it adds approximately 20mS latency when compared to a Taranis QX7 direct USB link.

Finally!!! I've been struggling with this problem for months.... Thanks!!!

doesnt work with mavic pro 2 remote control

If i have enable turtle mode through betafloght and then try this wiil it disconnect from tne previous setings(turtle mode);?

okay so i have a problem with my fpv drone (Eachine Novice 3). When i put the battery on or plug the usb into it. Then after 20 seconds its mega hot. Like it overheats.
Does someone have this problem too? Also am i supposed to leave the drone on while playing in the simulator? If so then my drone is gona melt bro...

thank you. can i link my tinygo with my pc with just same commands?

Futaba nope ! why every one say Connect any transmitter to any sim..not at all ! 24 hours I been searching (

When I pressed connect it says failed to open serial port does anyone know what that means and how to fix it?

I can’t connect my tiny hawk controller?

i did this and now my tiny hawk 2 freestyle wont show up in betaflight, I tried everything possible.

How do I disable usb_hid_cdc? After enabling it, I am unable to connect to BetaFlight as the COM port doesnt show up. But, yes I can play the simulator with the FlySky i6x joystick and FlightController (SkyStars HD F405).

When I go onto FPV Skydive it doesn't pick up any controller movements, plus now I cant get into BetaFlight as it says "Failed to open serial port". But i do know from before when I could get into BetaFlight that it was picking up the movements of my controller. Please help!

I am sorry, i am noob at this. How do it use it with a drone? as i only got radio controller

Does this work on macOS too? the CLI throws me Error: Invalid name

Does this work with a tiny hawk 2 freestyle

what can i do if i dont have a drone but an rc for an fpv drone

i have a dji mini 2 controller (normal version) and when i booted it on and tried to connect to controller it says failed to open serial port and it says on it "/dev/rfcomm0" what should i do?

can i use my dji mini 2 drone controller to a fpv sim ?

i dont have a drone but i want to connect to a simulator and practice before i buy one.Can you pls help me?

I have drone e95 pro i dont have any usb cable to pad i only have 3 batteries

How do i connect my drone into betaflight?

I have a DJI Phantom 4 remote, can I connect the SIM?