- Tricks for Installing Floating House Numbers: HY-KO PRODUCTS CO FM-6/2 Address Numbers

Pretty cool!! No led accents? Nah nah nah, might be overkill. Lol.

THANK You! I bent the first anchor, walked away for five minutes, came inside, watched this video, and then went out and finished the project, properly. I REALLY appreciate you making this video.

Use a 7/32nds drill bit. Use a rubber hammer (not your hat) and hopefully you'll have better luck than I did with the standoff barrels which did NOT neatly slide over the mounting screws!! (ID was too small!) Great numbers but crappy hardware and instructions HY-KO!

This video should have been called: How to show my hardware and drill a hole on my wall.

Don’t the screws have to be screwed into the wall or do they just slip inside the anchor? I don’t understand how the screws are mounted. Are they really just pounded in to the wall?

This sissy millennial narrator has prettier hands than a runway model

Bless your heart. I was like, "this is never going to work"

I can’t figure out how to take mine off to paint my siding. It was not float mounted. Please any suggestions would help.

What is the exact length of those spacers? They look slightly less than an inch?

Awesome. Very helpful.

You can skip the templates (which in my case weren't accurate at all) by inserting the hardware into the back of each number then use a rubber mallot to gently tap the numbers where you want them leaving a mark where the actual screws are, then drill holes there. Just use a level and tape off the appropriate edge and dividing spaces first.

So Very Helpful....I accomplished this task All by my lonesome, Thanks to Beau's Helpful, Easy, Detailed instructions and presentation. Thank you Thank you Thank you!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Thank you for posting. Very informative!

Very helpful thank you

Very helpful. Biggest thing I got out of this was that the packaging is the template. I didn’t even notice that. Almost tore the packaging to bits.

Is it the same process if you’re installing on brick?

VERY HELPFUL. THANK YOU SO MUCH

The instructions say to use a 1/4” drill bit, if you are using the anchors.

Good job on the video, you answered my questions with your explanations.

Should I use those anchors on cedar post? Or should I not use it? Thanks.

Saved me alot of headache! Thank you