THIS TRICK MAKES TESTING EASY!

👍👍

Great content

Nice video as you have a wander lead why do you do R1+R2 it’s a lot easier to just do a R2 and you are checking earth to any metal device at the same time

Top electrician

The spur off the ring main in the consumer unit goes to a switched fused spur first doesnt it? Therefore, you can add as many sockets as you like after that as the cable is protected by the 13amp fuse. I know it is not ideal, but im sure it is within the regs?

I really like your video. Regards the insulation test.just wondering why yo are not doing.line neutral to earth. Looping out your line and neutral. To earth.

Your high Zs could be down to the Fluke. Did you null out the three leads using the Fluke metal adaptor first?

adding ciruit resistance to ZE on a eicr is a no no, only on intial verification

Good description, which software do you use?

Its good your software comes up with the 80% Zs valves . I assume you can change it to the max tabulated or 80% as you need it?

Surely Ze should be measured at the meter not after a run to the Fuseboard, as it's a dno reading!?
If you move more circuits to a single RCD then that can create nuisance tripping!

I thought r1+r2 is not required on an eicr, rather should do live test to get proper realistic Zs no ?