How To Make A DIY Drink Dispenser (Tap) - In-Depth Look

Great video! Hope you post more!

Fantastic tutorial vid, really well done! Thanks so much for taking the time to make this and share! Looking forward to seeing more from you.

Very good tutorial! Quite impressive for your first video; instructions and details are exceptional. Will definitely watch for more!

Great tutorial! Instructions are clear and easy to follow 🙂 For your first video, you did a great job.

Good job on the video. I would like to see your take on an internet router box. It would need to hold the gateway router, mesh router, power strip and cables. Basically a box but nice looking. Thanks!

Is it ok to use 316 ss nipples and/or fittings?

Do you need tape? There’s no pressure

Ok, what is bottle?

Show

I kind of wish you would have shown it in action. I have done a fairly large amount of research into this and I am building a prototype now. The flow rate is really slow without a vent of some sort. I have decided to plumb in a small air pump into my design. I also found some really slick fittings that will allow for some additional features.

The 3M sandpaper is good but the small holes allow the Velcro to wear out over time then sandpaper won’t stay on

finally someone actually talking about the type of pipe to use that wont be harmful to your health. Great tutorial I learned a lot from this video. Thanks,

How do you get the liquor to only go to the tap and not fill the pipe all the way to the bottom?